Floor area of a property in Bulgaria: built-up, net, title-deed and cadastral area — why the numbers differ and which one matters when you buy
At the viewing the flat is "78 square metres". The title deed says 71 sq m built-up area plus undivided shares. The cadastral sketch shows a third figure and the tax valuation certificate a fourth. The buyer rightly asks which one is correct.
Usually they all are, but they measure different things. The trouble starts when the price is agreed on one area and the deed states another.
The four areas at a glance
| Area | What it includes | Where you see it |
|---|---|---|
| Built-up area of the flat | The home up to the outer face of its walls, balconies and loggias included | Title deed, design, cadastral register |
| Gross area ("with common parts") | The built-up area plus the undivided shares in the building's common parts | Listings and developer price lists, the deed |
| Net (usable) area | The floor between the inner walls, the space you actually furnish | Architectural plans, your own measurement |
| Area for tax valuation | Calculated under a method in the Local Taxes and Fees Act, with an addition for the basement and attic | Tax valuation certificate |
What the law says about built-up area
The Spatial Development Act defines these terms for a building, not for a single flat:
- Built-up area is the area within the outer contour of the enclosing walls of the first above-ground floor (§ 5, item 15 of the Additional Provisions of the Act).
- Gross built-up area is the sum of the built-up areas of all above-ground floors. It includes the full area of balconies, loggias and terraces (§ 5, item 18).
The same logic is used in practice for a flat. That is why a flat's built-up area is always larger than the floor you walk on. It includes the walls and the whole of the balconies.
A similar method is set out for tax valuation. The area is measured from the outer face of the façade walls to the middle of the walls shared with neighbouring units (Art. 11(1), Annex 2 to the Local Taxes and Fees Act). The method used in a particular design may differ, though. With a new building, ask exactly how the area was measured.
Undivided shares in the common parts
The staircase, the entrance, the roof, the land under the building and the other common parts belong to all the owners (Art. 38 of the Property Act). Each owner's share is proportional to the value of their unit, calculated when the building's shared ownership was created. Later changes to a unit do not alter the share (Art. 40).
The deed states these shares as a percentage and often also in square metres. They are not a room you use on your own. That is why a price per "gross" square metre cannot be compared with a price per built-up square metre. We covered how this affects comparing new and older homes in new-build or resale.
The basement, the attic and the tax valuation
A basement storage room or an attic room is appurtenant to the flat. The deed describes it separately, with its own number and area, and it is not part of the living area.
For tax valuation, however, 30% of the gross area of the basement or attic is added to the area of the flat (Art. 11(2) and (3), Annex 2 to the Local Taxes and Fees Act). The area on the tax valuation certificate can therefore be larger than in the deed. That is normal and does not point to an error.
The area in the title deed
The Registration Regulations require the description of the property to include "the area and/or the built-up area" (Art. 6(1)(c)). The notary usually carries the area over from the previous title document or from the design.
Two consequences follow:
- An older deed may state an area measured differently, or measured before an alteration.
- A glazed or "merged" balcony does not increase the area in the deed. It changes only on the basis of approved documents.
The area in the cadastre
The cadastral map shows the exact boundaries of the plot and of the building. Flats are different. According to the Geodesy, Cartography and Cadastre Agency, the schemes of self-contained units show their position relative to one another floor by floor, but contain no data on their exact dimensions. The area of a flat in the cadastral register is a recorded figure, not the result of a measurement on site.
That is why it can differ from the deed, especially in buildings entered in the cadastre on the basis of old documents. A sketch or scheme is attached to the notarial deed and the notary compares the description. A large difference can hold up the deal until the data has been corrected under the Cadastre and Property Register Act.
Why the numbers differ: the usual reasons
- Different methods. One area runs to the outer face of the walls, another between the inner walls.
- Undivided shares. The listing includes them, the cadastre does not.
- Balconies. They count in full in the built-up area but not in the net area.
- Old documents. The area was carried over from a deed decades old.
- Appurtenant rooms. Part of the basement and attic is added for the tax valuation.
- Changes during construction. With a new build, the area as built can differ from the design area in the preliminary contract.
What to do as a buyer
- Compare the four documents before paying a deposit: the listing, the deed, the scheme and the tax valuation. If the areas differ by more than the reasons above explain, ask why. The rest of the checks are in our guide to legal checks before buying a property.
- Find out which area the price is based on. A "price per square metre" without that detail tells you nothing.
- Write the area precisely into the preliminary contract. State the built-up area, the undivided shares and the appurtenant rooms separately. With a new build, agree what happens to the price if the area as built differs from the design. More on the stages in buying new-build property.
- If the furniture matters, measure it yourself. The net area decides whether the wardrobe will fit. The budget for finishing a shell flat is covered separately in the second budget.
If after the purchase the area turns out to be substantially smaller than agreed, the buyer can seek protection under the rules on the seller's liability (Arts. 193 and 195 of the Obligations and Contracts Act), for example a price reduction. For real estate the limitation period is one year from handover, or three years if the seller knowingly concealed the problem (Art. 197). Whether a particular difference is substantial is for the court to decide. It is safer to settle the question before the notary.
What to do as a seller
List the area as it appears in the deed and say what each figure includes. If you quote a "gross" area, say so explicitly. Order the cadastral scheme when you start preparing the documents. That way a mismatch with the deed comes to light weeks before the deal, not in the notary's office.
In short
- Built-up area includes the walls and the whole of the balconies (§ 5, items 15 and 18, Spatial Development Act). Net area is the floor between the inner walls.
- Undivided shares in the common parts are not a room of your own. A price per "gross" area cannot be compared with a price per built-up area.
- The cadastre does not measure flats. The schemes of self-contained units contain no exact dimensions.
- The tax valuation adds 30% of the basement and attic area, so it usually shows more.
- Agree in the preliminary contract which area you are buying and what happens if it differs.
If the numbers in the listing, the deed and the sketch of a property you like do not add up, call us or come into the office. We will compare the documents with you and tell you which area you are actually buying.
The information is general and indicative and does not replace a consultation.
